The Sanicompact is a self contained system that is used to install a half-bathroom up to 9 feet below the sewer line, or even up to 100 feet away from a soil stack, with gravity fall. The Sanicompact can handle the effluent from a toilet and sink and should only be used in a private, residential setting. It is not recommended for commercial or industrial applications.
The Sanicompact is a combination of a vitreous china toilet bowl and macerator/pump built into one compact unit. This modern shaped self-contained toilet is especially designed with several ideas in mind:
The Sanicompact needs no toilet tank as the flushing action and macerating pump cycle is automatic after pressing a dual flush push button on top of the bowl. The flushing mechanism is electrically timed to allow approximately 1 gallon (4 liters) of water to pass through the toilet.
By pressing the dual flush push button, this activates a timer and a solenoid valve in order to fill and wash the sides of the bowl. The motor starts and the waste and paper are pulled inside where it is macerated and pumped away. The motor stops after approximately 10-15 seconds and the timer programs the refill of the bowl with fresh water.
The Sanicompact includes soft-close toilet seat along with mounting hardware kit.
The inside of the Sanicompact is comprised of a pressure switch and circuit board assembly, which starts and stops the unit, and the motor, which drives the blade and the pump. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter, enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM. The reduced solids are picked up and the impeller mounted beneath the motor ejects the waste. The unit pumps the effluent upward to 9 feet and/or 100 feet horizontally (with gravity fall).
The discharge elbow on the back of the Sanicompact can be rotated 360 degrees to fit any type of installation required. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.
The Sanicompact is a forced main and does not need to vented and connected to a vent stack. Other fixtures may need to be vented as per local plumbing codes. It is also highly recommended for the macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit.
The Sanicompact has been certified to American and Canadian Standards. Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9.
Regular descaling with specially formulated Saniflo descaler will prolong the unit's life and maintain optimum performance. It is specifically created for use with Saniflo products and laboratory formulated with phosphoric acid. Regular usage prolongs unit life and maintains efficiency and it is harmless to septic tank operation.
|Maximum Temperature (°F)||95|
|Discharge Rate at Max. Height (gpm)||13|
|Min. Gravity Fall on Horizontal Run||1/4" per foot|
|Dimensions (Height x Width x Depth) (in)||18 ½" x 14 ½" x 21 ½"|
|Water Consumption (gallons)||1|
|Motor Speed (HP)||3600|
|Discharge Pipe Diameter (in)||1"|
|Vertical Discharge (ft.)||9|
|Horizontal Discharge (ft.)||100|
|Electrical Supply (V/Hz)||115|